Nassau County · Public water, some private wells (Inc. Village of Sands Point (Sands Point Wate…)
Water Quality in Sands Point, NY — What’s In Your Water
Sands Point's water is supplied by Inc. Village of Sands Point (Sands Point Water Department). The most recent published results show Chloride at 26.27 mg/L, Nitrate at 3.90 mg/L. Every figure below is shown against its NY or EPA limit and cited to its source.
Reported contaminants
Sands Point water, by the numbers
ND means not detected. Units: µg/L is micrograms per liter (parts per billion); ng/L is nanograms per liter (parts per trillion); mg/L is milligrams per liter (parts per million). Status uses the words below, near, exceeds, or trace — not color alone.
| Substance | Detected level | Limit | Status |
|---|---|---|---|
| PFAS | |||
| PFOA (about this substance) | 3.41 ng/LRange <2.2–11.0 | 10NYS MCL | Exceeds limit |
| PFOS (about this substance) | 1.29 ng/LRange <1.9–4.30 | 10NYS MCL | Below limit |
| PFHxS (about this substance) | 0.92 ng/LRange <1.8–1.9 | No regulatory limit | — |
| PFBA (about this substance) | 4.12 ng/LRange <1.8–5.60 | No regulatory limit | — |
| PFHxA (about this substance) | 2.77 ng/LRange 2.3–3.30 | No regulatory limit | — |
| PFPeA (about this substance) | 3.60 ng/LRange 2.7–4.6 | No regulatory limit | — |
| PFHpA (about this substance) | 2.07 ng/LRange <1.8–3.20 | No regulatory limit | — |
| PFBS (about this substance) | 1.95 ng/LRange <1.9–2.70 | No regulatory limit | — |
| Industrial solvents & 1,4-dioxane | |||
| 1,4-Dioxane (about this substance) | 0.032 µg/LRange <0.020–0.044 | 1NYS MCL | Below limit |
| Nitrate, metals & inorganics | |||
| Manganese (about this substance) | 0.27 mg/LRange <0.010–0.047The report prints an average of 0.27 mg/L, above the printed maximum of 0.047 mg/L. | 0.30NYS secondary standard | Near limit |
| Nitrate (about this substance) | 3.90 mg/LRange <0.050–4.70 | 10EPA MCL | Below limit |
| Iron (about this substance) | 0.049 mg/LRange <0.020–0.36Highest single result 0.36 mg/L. The report's violation column is No. | 0.30NYS secondary standard | No violation reported |
| Sulfate (about this substance) | 31.12 mg/LRange 13.1–43.8 | 250NYS secondary standard | Below limit |
| Chloride (about this substance) | 26.27 mg/LRange 11.1–56.8 | 250NYS secondary standard | Below limit |
| DCPA mono and di-acids | 2.84 µg/LRange <.10–1.8 | 50EPA MCL | Below limit |
| Gross beta (about this substance) | 1.72 pCi/LRange 1.13–2.81 | 50EPA MCL | Below limit |
| Barium (about this substance) | 0.033 mg/LRange 0.02–0.042 | 2EPA MCL | Below limit |
| Sodium (about this substance) | 19.34 mg/LRange 6.4–33.9 | No regulatory limit | — |
| Magnesium (about this substance) | 11.64 mg/LRange 6.1–17.4 | No regulatory limit | — |
| Calcium (about this substance) | 24.04 mg/LRange 15.0–30.4 | No regulatory limit | — |
| Nickel (about this substance) | 0.0038 mg/LRange <0.00050–0.0075 | No regulatory limit | — |
| Nitrate-Nitrite (as N) (about this substance) | 3.91 mg/LRange <0.050–4.7 | No regulatory limit | — |
| Radium-228 (about this substance) | 0.56 pCi/LRange 0.0856–1.21 | No regulatory limit | — |
| Combined Radium 226/228 (about this substance) | 1.21 pCi/LRange N/A–N/A | No regulatory limit | — |
| Uranium (about this substance) | 1.31 pCi/LRange N/A–N/A | No regulatory limit | — |
| Alkalinity (about this substance) | 67.91 mg/LRange 46.8–72.1 | No regulatory limit | — |
| Total Dissolved Solids (about this substance) | 190.45 mg/LRange 105–247 | No regulatory limit | — |
| Color (about this substance) | 5 units | No regulatory limit | — |
| Odor (about this substance) | 1 TON | No regulatory limit | — |
| Lead & copper | |||
| Copper (about this substance) | 0.24 mg/L(90th percentile)Range <0.054–0.36 | 1.3EPA action level | Below limit |
| Lead (about this substance) | 2.1 µg/L(90th percentile)Range <1.0–2.6 | 15EPA action level | Below limit |
| Disinfection byproducts | |||
| Chloroform (about this substance) | 1.04 µg/LRange <0.50–2.30 | 50EPA MCL | Below limit |
| Total Trihalomethanes (about this substance) | <2.0 µg/LRange N/A–N/A | No regulatory limit | — |
| Turbidity (about this substance) | 3.71 NTURange < 1.0–65.0 | No regulatory limit | — |
Water characteristics
| Substance | Detected level | Limit | Status |
|---|---|---|---|
| Free Chlorine (about this substance) | 0.9 mg/LRange 0.5–1.50 | 4.0EPA MRDL | Below limit |
| Calcium hardness (about this substance) | 24.11 mg/LRange 15.0–75.9 | No regulatory limit | — |
| Hardness (total) (about this substance) | 108.86 mg/LRange 65.9–136 | No regulatory limit | — |
| pH (about this substance) | 7.2 Std UnitsRange 7.0–7.2 | No regulatory limit | — |
Status reflects the average of all samples. Individual readings may be higher; see range.
Where the report prints both an average and a range, the status column here is judged on the average; where it prints a maximum or a 90th-percentile result, that figure is used. The report carries 3 notices: Table 1 PFOA row prints Violation 'Yes' (Maximum 11.0 ng/l on 03/18/25 against *MCL=10, NY State MCL); Likely Source cell begins 'Well was offline for when high was detected.' On September 18, 2025. NCDH observed a pH of 5.89 from an analyzer inside pumpstation of Well 3 N 43898 due to a caustic soda injection leak and issued the Village a Violation for change in treatment process without notification to the NCDH. At the time of incident Well 4 with fully functioning treatment was in lead and well 3 was set to last on first off position. The well ran during peak irrigation hours. Both wells running together and mixing in system distribution while leaving the facility, (although pH readings were lower than normal when analyzed by handheld devices), were still receiving pH adjustment. At a distribution sample tap on site, not the continuous analyzer, the lowest observed pH was a 6.9. Although the system not being designed to operate this way the mixing of the two wells did produce treated water albeit above the targeted pH. Being that the system was not designed this way it was not found acceptable by the NCDH. Page 5 (Nitrate): 'As you can see by the table, our system had no violations, but we have learned through our testing that some contaminants have been detected; however, these contaminants were detected below New York State requirements. Although nitrate was detected below the MCL, it was detected at 0.05-6.6 which is greater than one-half of the MCL. Therefore, we are required to present the following information on nitrate in drinking water...' (mandatory nitrate health-effects language follows). About 40% of Sands Point's land lies inside a public water service area (Sands Point (Village)), per the NYS Department of Health boundaries EPA publishes; the rest is on private wells. These results apply only to public water.
Your water district
Who supplies Sands Point’s water
Inc. Village of Sands Point (Sands Point Water Department)
EPA compliance
Federal violation record for Sands Point’s suppliers
The annual report above lists what was found in the water. EPA’s compliance database records whether each supplier met its testing, treatment, and reporting obligations.
- Port Washington Water District
EPA ID NY2912267 · serves about 34,000 people
- Violations 2022–2026
- 1
- Health-based
- 1
- Last violation
- 2024
Compliance counts are EPA Safe Drinking Water Information System records pulled directly from EPA. Most violations are monitoring or reporting lapses, not unsafe water; health-based violations (a contaminant limit, disinfectant level, or treatment technique) are counted separately. A system listed for a ZIP code may serve only part of it.
What the numbers mean
Like most of Nassau, Sands Point runs on treated public water. The day-to-day concerns here are the chlorine and chloramine used to keep the supply safe through the distribution system, plus the naturally high hardness of Long Island groundwater — the mineral content that leaves scale on fixtures and spots on glassware. Neither is an emergency, but both are exactly what point-of-entry carbon filtration and softening are designed to address.
What this means for filtration
Matching Sands Point’s water to a system
For Sands Point, the numbers point first to under-sink reverse osmosis and whole-house carbon filtration: dissolved contaminants close to their limits.
- Recommended
Under-Sink Reverse Osmosis
Dissolved contaminants close to their limits
Nitrate averaged 3.9 mg/L (limit 10), moderate but present; reverse osmosis reduces it at the tap. PFOA/PFOS reached 11 ng/L (ppt) in at least one sample — above New York's 10 ppt limit and at or above the 4.0 ppt federal MCL, with federal compliance due April 26, 2029. Whether an under-sink reverse osmosis model reduces PFOA or PFOS depends on that model's certification or performance data sheet. The supplier's 90th-percentile lead result was 0.0021 mg/L (2 ppb) against the 15 ppb action level. Lead enters water from a home's own service line and fixtures, so the system figure says little about any one house; a filter certified for lead (NSF/ANSI 53) or reverse osmosis at the kitchen tap reduces it at the point you drink.
Explore Under-Sink Reverse Osmosis - Recommended
Whole-House Carbon Filtration
Chlorine residual 0.9 mg/L
Free chlorine averaged 0.9 mg/L at the entry point (limit 4), the residual that gives tap water its pool taste and dries skin and hair. Chlorination by-products (trihalomethanes) reached 2.3 µg/L in some samples against an 80 µg/L limit for the group; they are absorbed in the shower as well as drunk.
Explore Whole-House Carbon Filtration - Worth considering
Whole-House + Softener Combo
Hardness 109 mg/L, about 6.4 grains per gallon
At 109 mg/L (6.4 gpg) the water is moderately hard. A softener is a comfort choice here, not a necessity; some homes near the top of the 136 mg/L range will notice scale.
Explore Whole-House + Softener Combo - Worth considering
Private Well Treatment
Private wells in part of the community
Part of Sands Point is on private wells that none of these figures cover; a well needs its own test, and a well package is sized to what it finds.
Explore Private Well Treatment
Questions
Sands Point water FAQ
Nearby Nassau County towns
Free in-home test
See what’s really in your Sands Point water.
Published reports cover the public supply — a free in-home test measures your taps (and your well, if you have one), then we walk you through the results.