Skip to content
Fieldstone Water Co.

Water sources · The aquifer

Long Island's Aquifer: Where All the Water Comes From

Long Island has no reservoirs and imports no water. Every public supplier and every private well pumps from the same groundwater system under the island, which the U.S. EPA designated a sole source aquifer in 1978 because there is no practical alternative. Rain and snow falling on the island are the only thing that refills it.

At a glance

Pros and cons

Advantages

  • Naturally filtered through deep sand; no algae, silt or surface runoff to treat.
  • Stable temperature and chemistry through the year.
  • No dependence on upstate reservoirs or a long aqueduct.
  • Protected in law: a federal sole source designation and state limits on deep-aquifer drilling.

Trade-offs

  • Only rain refills it, so what soaks into the ground ends up in the water.
  • Contamination lingers for decades; plumes move slowly and cannot be flushed.
  • Shallow layers carry nitrate from fertilizer and septic systems.
  • Naturally hard in much of the island, with iron and manganese in places.
  • Salt water presses in along the coasts where pumping lowers the water table.

Three layers, one system

The island sits on layers of sand, gravel and clay laid down over millions of years and shaped by the last glacier. Water fills the spaces between the grains. Geologists name three main water-bearing layers, from shallow to deep: the Upper Glacial aquifer, the Magothy aquifer and the Lloyd aquifer.

The Upper Glacial is the water table, the layer closest to the surface. Most private wells draw from it, and so do some public wells, especially in Suffolk. Because it is shallow and the soil above it is sandy, whatever soaks into the ground reaches it first: lawn fertilizer, septic effluent, road runoff, spilled solvents.

The Magothy is the deep workhorse. Most public supply wells in Nassau and many in Suffolk draw from it. It is better protected by depth, but water moves down into it from the Upper Glacial over years and decades, so contamination that entered the shallow layer long ago can still be arriving.

The Lloyd is the deepest layer, resting on bedrock. New York restricts new wells in it, reserving it mainly for coastal communities whose shallower layers are vulnerable to salt water. Long Beach and the barrier islands depend on it.

Why it matters for your tap

Groundwater has real advantages over the rivers and reservoirs most of the country drinks from. It is filtered through hundreds of feet of sand, it is naturally free of the algae and sediment that surface water carries, and it is cold and stable year-round. Long Island suppliers do not need the heavy filtration plants that surface-water cities run.

The trade-off is that groundwater has a long memory. A chemical that soaked into the ground in the 1960s can show up in a well today, and once a plume is in the aquifer it cannot be flushed out the way a river clears itself. The two best-known Long Island examples, 1,4-dioxane and PFAS, are both legacies of past industrial and firefighting use that are still moving through the sand.

Nitrogen is the other island-wide story. Fertilizer and the effluent from hundreds of thousands of cesspools and septic systems feed nitrate into the shallow aquifer, where it shows up in private wells and, eventually, in bays and harbors.

Hardness and the island's chemistry

Water that sits in sand and gravel picks up minerals. Long Island groundwater is naturally hard in much of Nassau and western Suffolk and softer toward the East End, which is why hardness is the most common complaint on public supply and why softeners are so widely installed here.

Iron and manganese are also natural in parts of the aquifer, more so in Suffolk. They are not health limits, but they stain fixtures and laundry and are the reason some supplier reports flag iron above its secondary standard.

What to do

If this is your water

  1. 1.Find out which layer your water comes from

    Public suppliers name their wells and depths in the annual report; your community page links to it. Private well owners can find the well depth on the original well completion report or by asking the driller.

  2. 2.Read your community's results against the limits

    Every substance a supplier reported, with its range and limit, is on your community page. The pattern of what is detected tells you which part of the aquifer story applies to you.

  3. 3.Test what reaches your tap

    The supplier's figures describe the system at the wellhead. A free in-home test shows what comes out of your faucet after the pipes in your street and your house.

Questions

Common questions

Sources

Start here

Find out what reaches your tap.

A free in-home test measures what is actually in your water, whatever its source, and tells you whether treatment is worth it and when a certified laboratory test is the right next step.